Ps Retarder

Sén - Phénix

Ps Retarder

The contribution of the concrete surface retarder

DESCRIPTION

PS RETARDER, cement concrete surface of the decorative image revealing sherbet agregalarını outlet delay a chemical admixture of concrete


STANDARDS

ASTM C 494 - 81 Type B; TS EN 934 - 2


AREAS OF USE

  • In-situ and precast concrete surfaces of the aggregates required to appear

  • (Wash beton - exposed aggregate concrete)

    FEATURES

  • Comcrete surface more resistant to weak layerconsisting of a surface layer of hard aggregates is abtained.
  • Acquire an image is decorative

  • COMPLIANCE

    PS RETARDER, the following materials can be used.

  • Portland, sulphate resisting cement and other types
  • Air entraining and other concrete additives
  • Delaying or accelerating additives usend in conjunction with hihg-dose pre-trial should be performed.

  • CONSUMPTION

    According to the desired etch depth of 100-200 g/m2

    APPLICANTION

  • PS RETARDER, brush, roller or spray applied.
  • 1:3 ratio of the material until the desired degree of roughness and impact diluted
  • Be sure that the molds are clean, new timber mold or molds, the application of two coats should be vey absorbent. .
  • Open mold surface pressure washed with water immediately after application

  • TECHNICAL DATA

    View brownish liquid
    1.16 + 0.03 gr/cm3 density(20 C)
    Chloride 0.1% (EN 480-10)
    Alkali 2 % % (EN 480 - 12)
    Consumption 100-200 gr / m2